|
Size: 1441
Comment:
|
← Revision 5 as of 2013-07-12 18:17:44 ⇥
Size: 1465
Comment: converted to 1.6 markup
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 2: | Line 2: |
| ||<:30%>[:PiraScheme#Mechanics: Table of Mechanics Demonstration]||<:30%>[:MEEquipmentList: List of Mechanics Equipment & Supplies]||<:30%>[:Demonstrations:Lecture Demonstrations]|| | ||<:30%>[[PiraScheme#Mechanics| Table of Mechanics Demonstration]]||<:30%>[[MEEquipmentList| List of Mechanics Equipment & Supplies]]||<:30%>[[Demonstrations|Lecture Demonstrations]]|| |
| Line 8: | Line 8: |
| * '''Cabinet:''' [:MechanicsCabinet:Mechanic (ME)] * '''Bay:''' [:MechanicsCabinetBayA5:(A5)] |
* '''Cabinet:''' [[MechanicsCabinet|Mechanic (ME)]] * '''Bay:''' [[MechanicsCabinetBayA5|(A5)]] |
| Line 12: | Line 12: |
| attachment:ForceSensor01-400.jpg | {{attachment:ForceSensor01-400.jpg}} |
| Line 16: | Line 16: |
| This device is used in conjunction with the [:PASCOInterfaceComputer:PASCO Interface & Datastudio] to measure an applied force. | This device is used in conjunction with the [[PASCOInterfaceComputer|PASCO Interface & Datastudio]] to measure an applied force. |
| Line 25: | Line 25: |
| 1. Setup the PASCO interface and Datastudio as documented on [:PASCOInterfaceComputer:PASCO Interface & Datastudio] | 1. Setup the PASCO interface and Datastudio as documented on [[PASCOInterfaceComputer|PASCO Interface & Datastudio]] |
| Line 36: | Line 36: |
| attachment:ForceSensor02-250.jpg | {{attachment:ForceSensor02-250.jpg}} |
| Line 38: | Line 38: |
| attachment:DataStudio03-1000.jpg attachment:DataStudio04-1000.jpg |
{{attachment:DataStudio03-1000.jpg}} {{attachment:DataStudio04-1000.jpg}} |
| Line 42: | Line 42: |
| [:Instructional:Home] | [[Instructional|Home]] |
PASCO Force Sensor, 1A.EQ102
Location:
Cabinet: Mechanic (ME)
Bay: (A5)
Shelf: #1
Description:
This device is used in conjunction with the PASCO Interface & Datastudio to measure an applied force.
Important Setup Notes:
- N/A
Setup and Procedure:
Setup the PASCO interface and Datastudio as documented on PASCO Interface & Datastudio
- Connect the force sensor to the interface with attached cable.
- Configure the device in Datastudio by clicking on the proper channel (See pictures below for screenshot).
- Select device being used,Force Sensor in this case.
- Before using the device, it must be zeroed which is done by pushing the tare button located on the side of the device (pictured below).
Cautions, Warnings, or Safety Concerns:
This device has a 50 N force limit!
