243
edits
3D printing: Difference between revisions
Jump to navigation
Jump to search
→Polycarbonate
ElenaZhivun (talk | contribs) |
ElenaZhivun (talk | contribs) |
||
|
* Warped parts can be trimmed down with a knife
* It's very difficult to remove supports from the small drill holes. The holes end up being deformed as well.
* 1/2 inch Thorlabs posts printed from the thorlabs models don't fit into their post holders. (They technically fit, but are too tight to be practical.)
* The printed parts can be machined
* If bent along the fibers, the models can take a lot of deformation without cracking
| |||