Table DMM & Timer, 3A.EQ.100

Location:

• Cabinet: [:WavesSoundCabinet#WavesSoundLt:Waves and Sound (WS)]

• Bay: [:WSCabinetLtBayB2: B2]

• Shelf: 2

attachment:BenchMeterInterface01-400.jpg

Description:

This is a homemade multimeter.

Important Notes:

• N/A

Setup:

1. Plug in the blue Tyco chip in the back to show a decimal place. Moving the resistor on the card will move decimal place location.
2. Plug the 9 pin flat wire from the back to the DMM to the leg of one of the display table that contain an 8 digit external display.
3. Connect input to either channel A or B or both can be used if there are two inputs. There is a toggle switch for switching between the channels.
4. Select desired measurement type: frequency counter, timer, resistance, current, or voltage by pressing corresponding button.
5. Select desired scaling by pressing corresponding button (not applicable to frequency or current): 2 kΩ to 20 kΩ, 2 mA to 2 A, and 20 V to 2000 V.
6. If using the timer option, there is a start/stop and a reset button on the front of the unit. The Cat5 switch also performs these functions.

Cautions, Warnings, or Safety Concerns:

• N/A

[:Instructional:Home]