|
Size: 1271
Comment:
|
Size: 1441
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 16: | Line 16: |
| This device is used in conjunction with the [:PASCOInterfaceComputer:PASCO Interface & Datastudio] | This device is used in conjunction with the [:PASCOInterfaceComputer:PASCO Interface & Datastudio] to measure an applied force. |
| Line 29: | Line 29: |
| 1. Before using the device, it must be zeroed which is done by pushing the tare button located on the side of the device (pictured below). |
[:PiraScheme#Mechanics: Table of Mechanics Demonstration] |
[:MEEquipmentList: List of Mechanics Equipment & Supplies] |
[:Demonstrations:Lecture Demonstrations] |
PASCO Force Sensor, 1A.EQ102
Location:
Cabinet: [:MechanicsCabinet:Mechanic (ME)]
Bay: [:MechanicsCabinetBayA5:(A5)]
Shelf: #1
attachment:ForceSensor01-400.jpg
Description:
This device is used in conjunction with the [:PASCOInterfaceComputer:PASCO Interface & Datastudio] to measure an applied force.
Important Setup Notes:
- N/A
Setup and Procedure:
Setup the PASCO interface and Datastudio as documented on [:PASCOInterfaceComputer:PASCO Interface & Datastudio]
- Connect the force sensor to the interface with attached cable.
- Configure the device in Datastudio by clicking on the proper channel (See pictures below for screenshot).
- Select device being used,Force Sensor in this case.
- Before using the device, it must be zeroed which is done by pushing the tare button located on the side of the device (pictured below).
Cautions, Warnings, or Safety Concerns:
This device has a 50 N force limit!
attachment:ForceSensor02-250.jpg
attachment:DataStudio03-1000.jpg attachment:DataStudio04-1000.jpg
[:Instructional:Home]