Differences between revisions 11 and 16 (spanning 5 versions)
Revision 11 as of 2012-06-18 19:59:21
Size: 2850
Editor: srnarf
Comment:
Revision 16 as of 2013-06-25 19:18:00
Size: 2997
Editor: srnarf
Comment:
Deletions are marked like this. Additions are marked like this.
Line 18: Line 18:
This older Welch Scientific apparatus is designed with a spring loaded device that simultaneously drop one steel ball while shooting another steel ball horizontally. This older Welch Scientific apparatus is designed with a spring loaded device that simultaneously drops one steel ball while shooting another steel ball horizontally.
Line 22: Line 22:
||Drop Shot Apparatus||ME, [:MechanicsCabinetBayA5:Bay A5], Shelf #2||1D60.20|| ||Drop Shot Apparatus|| [:MechanicsCabinetBayA5:ME Cabinet Bay A5, Shelf #2] ||1D60.20||
Line 54: Line 54:
 * [http://youtu.be/iNHnDHiUJYY Drop & Shot, 1D60.20]
Line 55: Line 56:
 * [http://www.youtube.com/watch?v=D9wQVIEdKh8 MythBusters Bullet: Fired vs. Dropped]
Line 59: Line 60:
 * N/A
 * NA

[:PiraScheme#Mechanics: Table of Mechanics Demonstration]

[:MEEquipmentList: List of Mechanics Equipment & Supplies]

[:Demonstrations:Lecture Demonstrations]

Drop & Shot, 1D60.20

Topic and Concept:

Location:

attachment:DropShot-02-400.jpg

Abstract:

This older Welch Scientific apparatus is designed with a spring loaded device that simultaneously drops one steel ball while shooting another steel ball horizontally.

Equipment

Location

ID Number

Drop Shot Apparatus

[:MechanicsCabinetBayA5:ME Cabinet Bay A5, Shelf #2]

1D60.20

Ring Stand

Rod and Stand Cabinet

Bench Clamp

Rod and Stand Cabinet

Important Setup Notes:

  • N/A

Setup and Procedure:

  1. Attach a vertical rod stand to the bench.
  2. Clamp the apparatus to the rod with the apparatus extending over the edge of the bench, so that when the gun is fired the two balls will miss the bench.
  3. Cock the apparatus and place the ball with the whole through it, on the horizontal shaft of the gun.
  4. Place the other ball in the dimple on the other side of the apparatus.

Cautions, Warnings, or Safety Concerns:

  • Pay attention to where the balls will land.

Discussion:

Tell students to pay attention to the vertical motion of balls. The fact that one of them has a horizontal velocity does not affect its motion in the vertical direction. The balls hit the ground at the same time. Make the analogy about simultaneously firing a bullet out of a gun and dropping one from the end of the barrel.

When the gun is fired the shaft is drown out of the ball and that ball drops vertically to the floor. The other ball on the other end of the apparatus gets hit by the sliding rod and sends this ball fling in the horizontal direction. Both balls are set into motion at the same time when the gun is fired and shows that the two balls will strike the floor at the same time despite the difference in the ball's trajectories. The two balls striking the floor can be observed by the simultaneous sounds at the point of impact.

attachment:DropShot-02-250.jpg

attachment:DropShot-06-250.jpg

attachment:DropShot-07-250.jpg

attachment:DropShot-09-250.jpg

attachment:BenchRodClamp-01-250.jpg

Videos:

References:

  • NA

[:Instructional:Home]

fw: DropShot (last edited 2018-07-18 16:29:22 by srnarf)