FMCG/Data Acquisition with LabVIEW Software: Difference between revisions

# The '''misc.''' and '''changelog''' tabs are not used on a day-to-day basis.

 

To acquire more data simply click '''STOP''', and decide what you'd like to do.

# If there was an error during any of the calibration steps, simply click the '''Run''' arrow again. You'll start over from the beginning, except you'll be given prompts asking if you'd like to recalibrate either the circuit or magnetometer. The circuit only needs to be recalibrated if the chirp amplitude or output resistor is changed. The magnetometer should be recalibrated after any changes to the temperature, bias fields, or laser intensities/detunings. On the next run, the '''Run''' value at the top left will increment by 1, and the '''Noise''' value will reset to ''00''.