Differences between revisions 23 and 29 (spanning 6 versions)
⇤ ← Revision 23 as of 2018-04-26 18:33:57 →
Size: 1610
Editor: ChadSeys
Comment:
← Revision 29 as of 2018-06-12 19:17:43 → ⇥
Size: 1868
Editor: PriyaPathare
Comment:
Deletions are marked like this. Additions are marked like this.
Line 10: Line 10:
[[attachment:M-12b-200.png|{{attachment:M-12b-200.png||width=500 height=185}}]]
Line 12: Line 11:
[[attachment:M-12b-200.png|{{attachment:M-12b-200.png|attachment:M-12b-200.png|width="500 height=185"}}]]
Line 15: Line 15:
 * 1 [[4327-1#PASCO_Hooke.27s_Law_Unit|Hooke's Law Unit]]
Line 23: Line 24:
 *  1 Motion Sensor  * 1 [[4327-2#PASCO_Motion_Sensor|Motion Sensor]]
Line 25: Line 26:
  * w/ 0.25" T-Stand
  * w/ Right Angle Clamp
  * 1 [[4327-2#Small (1/4") Stainless Steel Rod|0.25 in. Steel Rod]]
   * w/ [[4327-1#S-W_T-Base_1.2BAC8-4.22_Support_Stand|1/4" T-Stand]]
Line 31: Line 29:
  * w/ [[4327-3#PASCO_Photogate_Cord|Cord]] If Not Attached   * w/ [[4327-3#PASCO_Photogate_Cord|Cord]]
Line 34: Line 32:
===== Also for Classroom =====
 * 2 [[4327-1#PASCO_Hooke.27s_Law_Unit|Hooke's Law Units]]		 ==== Also for Classroom ====
Line 40: Line 37:
 * For pairs of tables, air supplies should be on chairs between the tables. Run two tracks from one supply via a Hose-T.
 * For tables against a wall, air supplies should be on the table next to the Pasco interfaces.

 * Position adjustable stop at mid-point
 * Attach springs toglider, stop and end-points
Line 44: Line 47:
 * Always Run 2 Tracks From Same Air Supply

M-12b: Air Track Resonance & Simple Harmonic Motion

Quantity: 14

Contents

  1. M-12b: Air Track Resonance & Simple Harmonic Motion
    1. Quantity: 14
    2. Experiment Contents
    3. Also for Classroom
    4. Check

  • Lab Table Setup

attachment:M-12b-200.png

Experiment Contents

Also for Classroom

  • 4 Boxes 25mm Springs

  • 1 Weight Box w/50g Weight Hangers (In Lab)

Check

  • For pairs of tables, air supplies should be on chairs between the tables. Run two tracks from one supply via a Hose-T.
  • For tables against a wall, air supplies should be on the table next to the Pasco interfaces.
  • Position adjustable stop at mid-point
  • Attach springs toglider, stop and end-points
  • Computer Set-Up (PC, Interface On Before Computer, Sensors Work)
  • Air Tracks Work (Clean, No Clogged Air Holes, Glider Movement)
  • Glider Accessory Kit Including Glider Bands
  • Hose Intact

200 Level Index M-12

il: M-212b (last edited 2018-06-12 19:17:43 by PriyaPathare)