|
Size: 1102
Comment:
|
Size: 1809
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 8: | Line 8: |
| <<Thumbnail(E-6-200.png,500,138)>> | [[attachment:E-6-200.png|{{attachment:E-6-200.png|attachment:E-6-200.png|width="500 height=138"}}]] |
| Line 13: | Line 13: |
| * 1 [[3323-1#Multimeter|Keithley 175 Digital Multimeter]] | * 1 [[3323-1#FlukeMultimeter|Fluke 115 Handheld Multimeter]] * w/[[Hanging PASCO Voltage Sensors#Fluke_Multimeter_Sensor|Hanging PASCO Voltage Sensors#Fluke Multimeter Sensor]] |
| Line 22: | Line 23: |
| * [[3323-9#Plug_Board_Kit|Plug Board Kit]] (29 Items) | * [[3323-9#Plug_Board_Kit|Plug Board Kit]] (30 Items) |
| Line 25: | Line 26: |
| * Capacitor Set (47nf, 1μf) | * Capacitor Set (47nF, 1μF, 0.47μF) |
| Line 27: | Line 28: |
| * Inductor (1 Hy) | * Inductor (1 H) |
| Line 34: | Line 35: |
| === Troubleshooting === If the output of the differential amplifier is unstable, the grounds should be checked. All E-6 equipment should be plugged into the Tripp Lite power strip, which is located adjacent to the lab table (see photo below), and the Tripp Lite power strip should be plugged into the wall. No E-6 equipment should be plugged into the power strip on the back of the computer cart. [[attachment:TrippLite.png|{{attachment:TrippLite.png|attachment:TrippLite.png|width="500 height=138"}}]] |
E-6: Cathode Ray Oscilloscope And Differential Amplifier
Quantity: 39
Contents
Experiment Contents
1 Function Generator (Krohn-Hite, Pasco)
w/Kit
1 UW Timer (Include Only If Using Krohn-Hite Type Function Generator)
Also
- 1 Oscilloscope Manual
Check
Plug Board Kit (30 Items)
- Resistor Set (1kΩ, 2.2kΩ, 3.3kΩ, 4.7kΩ, 10kΩ, 20kΩ, 100kΩ, 10MΩ)
- 8 Bridge Plugs
- Capacitor Set (47nF, 1μF, 0.47μF)
- Diode
- Inductor (1 H)
- SPDT Switch
- Variable Resistor (1k)
- Transistor (2N1480)
- Differential Amplifier
- Adapter Set (2 Pomona 1269, 2 Pomona 1296, 1 BNC 'T')
Troubleshooting
If the output of the differential amplifier is unstable, the grounds should be checked. All E-6 equipment should be plugged into the Tripp Lite power strip, which is located adjacent to the lab table (see photo below), and the Tripp Lite power strip should be plugged into the wall. No E-6 equipment should be plugged into the power strip on the back of the computer cart.
