|
Size: 1102
Comment:
|
Size: 1746
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 8: | Line 8: |
| <<Thumbnail(E-6-200.png,500,138)>> | [[attachment:E-6-200.png|{{attachment:E-6-200.png|attachment:E-6-200.png|width="500 height=138"}}]] |
| Line 13: | Line 13: |
| * 1 [[3323-1#Multimeter|Keithley 175 Digital Multimeter]] | * 1 [[3323-1#FlukeMultimeter|Fluke 115 Handheld Multimeter]] * w/[[Hanging PASCO Voltage Sensors#Fluke_Multimeter_Sensor|Hanging PASCO Voltage Sensors#Fluke Multimeter Sensor]] |
| Line 15: | Line 17: |
| Line 22: | Line 25: |
| * [[3323-9#Plug_Board_Kit|Plug Board Kit]] (29 Items) | * [[3323-9#Plug_Board_Kit|Plug Board Kit]] (30 Items) |
| Line 25: | Line 29: |
| * Capacitor Set (47nf, 1μf) | * Capacitor Set (47nF, 1μF, 0.47μF) |
| Line 27: | Line 31: |
| * Inductor (1 Hy) | * Inductor (1 H) |
| Line 34: | Line 38: |
| === Troubleshooting === If the output of the differential amplifier is unstable, the grounds should be checked. All equipment should be plugged into the Tripp Lite power strip, which is located adjacent to the lab table (see photo below), and the Tripp Lite power strip should be plugged into the wall. <<TableOfContents(4)>> [[attachment:TrippLite.png|{{attachment:TrippLite.png|attachment:TrippLite.png|width="500 height=138"}}]] |
E-6: Cathode Ray Oscilloscope And Differential Amplifier
Quantity: 39
Contents
Experiment Contents
1 Function Generator (Krohn-Hite, Pasco)
w/Kit
1 UW Timer (Include Only If Using Krohn-Hite Type Function Generator)
Also
- 1 Oscilloscope Manual
Check
Plug Board Kit (30 Items)
- Resistor Set (1kΩ, 2.2kΩ, 3.3kΩ, 4.7kΩ, 10kΩ, 20kΩ, 100kΩ, 10MΩ)
- 8 Bridge Plugs
- Capacitor Set (47nF, 1μF, 0.47μF)
- Diode
- Inductor (1 H)
- SPDT Switch
- Variable Resistor (1k)
- Transistor (2N1480)
- Differential Amplifier
- Adapter Set (2 Pomona 1269, 2 Pomona 1296, 1 BNC 'T')
Troubleshooting
If the output of the differential amplifier is unstable, the grounds should be checked. All equipment should be plugged into the Tripp Lite power strip, which is located adjacent to the lab table (see photo below), and the Tripp Lite power strip should be plugged into the wall.
Contents
