|
Size: 1949
Comment:
|
← Revision 8 as of 2013-07-12 18:17:41 ⇥
Size: 2029
Comment: converted to 1.6 markup
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 17: | Line 17: |
| ||Thermoelectric Magnet set||[:ThermoCabinetBayA4: TD, A4, Shelf #2]||<: > 5E50.30|| | ||Thermoelectric Magnet set||[[ThermoCabinetBayA4| TD, A4, Shelf #2]]||<: > 5E50.30|| |
| Line 26: | Line 26: |
| Note: Make sure that one of the red & white gas cart are in placed and the gas hose is connected to the utility trench gas line. The gas cylinder that supplies the gas to utility trench gas line may or may not be connected/installed and should be inspected. | |
| Line 27: | Line 28: |
| 1. Install the burner gas tube with the gas source. 1. Make sure that you have the gas switch off and in the right pressure that you want before you turn it on. |
|
| Line 39: | Line 38: |
| Clamp copper loop in magnet body and suspend magnet. Show the students that there is no magnetic power from the thermoelectric magnet by apply armature concentric with magnet body and it cannot attached to the magnet, then heat one junction with burner and cool the other with cold water. | Clamp copper loop in magnet body and suspend magnet. Show the students that there is no magnetic power from the thermoelectric magnet by apply armature concentric with magnet body and it cannot attach to the magnet, then heat one junction with burner and cool the other with cold water. |
| Line 51: | Line 50: |
| [:Demonstrations:Demonstrations] | [[Demonstrations]] |
| Line 53: | Line 52: |
| [:Instructional:Home] | [[Instructional|Home]] |
Thermoelectric magnet, 5E50.30
Location:
Cabinet: Thermodynamics Cabinet
Bay: (A4)
Shelf: #2
(attachment photo showing the fully set up demonstration)
Description:
The thermoelectric magnet consists of a copper loop wrapped around the iron core.
Equipment |
Location |
ID Number |
|
|
|
Thermoelectric Magnet set |
5E50.30 |
|
Burner |
|
|
Cold water |
|
|
Weight hanger |
|
|
Several kilograms masses |
|
|
2 1/2" rod with Clamp and connector |
|
|
Setup: Note: Make sure that one of the red & white gas cart are in placed and the gas hose is connected to the utility trench gas line. The gas cylinder that supplies the gas to utility trench gas line may or may not be connected/installed and should be inspected.
- Clamp the 1/2' rod with the table and the another one to make a hanger bar.
- Make sure that you clamp copper loop in magnet body and suspend magnet.
Cautions, Warnings, or Safety Concerns:
- Beware of heat flame.
- Demonstration may require practice.
Demonstration:
Clamp copper loop in magnet body and suspend magnet. Show the students that there is no magnetic power from the thermoelectric magnet by apply armature concentric with magnet body and it cannot attach to the magnet, then heat one junction with burner and cool the other with cold water. Apply armature concentric with magnet body again. Attach hanger and add weights as heating progresses. To function properly, magnet and armature must make perfect contact.
attachment other photos |
attachment other photos |
attachment other photos |
attachment other photos |
References:
- Central Scientific Co.
[Insert a back link to main topic list]