Differences between revisions 1 and 2

Resistance

PIRA classification 5D

Resistance Characteristics

PIRA #	Demonstration Name	Abstract
5D10.10	resistor assortment
5D10.11	scaled up resistor box	Rebuild an old resistance box with larger numbers.
5D10.20	characteristic resistances	Connect one meter lengths of various wires in series and measure the voltage across each.
5D10.20	characteristic resistance	Measure voltages on a commercial board with seven one meter lengths of various wires is series so all carry the same current.
5D10.20	resistance wires	Place 6V across a set of wires of different lengths and/or diameters and measure the currents.
5D10.22	resistance characteristic of arc	Measure the current and potential across a small arc as the series resistance is varied.
5D10.40	resistance model	Balls are rolled down an incline with pegs.
5D10.40	model of resistance	A ball is rolled down a board with randomly spaced nails.
5D10.40	charge motion demonstrator	Small balls are rolled down a board with nails scattered in an almost random pattern. Diagram.
5D10.40	electron motion model	Ball bearings are simultaneously rolled down two ramps, one with pegs and one without.
5D10.50	current model with Wimshurst

Resistivity and Temperature

PIRA #	Demonstration Name	Abstract
5D20.10	wire coil in liquid nitrogen	A lamp glows brighter when a series resistance coil is immersed in liquid nitrogen.
5D20.10	resistance at low temperature	A lamp glows brighter when a series resistance coil is immersed in liquid air.
5D20.10	cooled wire	A copper coil in series with a battery and lamp is immersed in liquid nitrogen.
5D20.11	resistance at low temperature	A "C" battery, 3 V flashlight bulb, and a copper wire coil make a hand held temp coefficient of resistivity apparatus.
5D20.12	audible temp-dependent resistance	The resistor plunged into liquid nitrogen is part of a voltage controlled oscillator that drives a speaker.
5D20.12	cooling	Current is increased in a long U of iron wire until it glows, then half is inserted into a beaker of water.
5D20.14	superconducting wire	Cool a coil of NbTi wire in a series circuit with a 12 volt car battery and lamp first in liquid nitrogen, then helium. The voltage across the coil is monitored and the lamp brightness is observed.
5D20.15	flame and liquid nitrogen	Resistance coils are heated and cooled with a test light bulb in series.
5D20.15	temperature dependence of resistance	Two sets of bulbs in series with coils, one put in liquid nitrogen and the other in a flame.
5D20.16	temperature coefficent of resistance	Two coils of different material but the same resistance are placed in a Wheatstone bridge and either is heated or cooled.
5D20.20	iron wire in flame	Heat a coil of iron wire in series with a battery and a lamp and the lamp will dim.
5D20.20	iron wire in a flame	A coil of forty turns of iron wire is heated in a flame while connected in series with a light bulb circuit.
5D20.20	putting the light out by heat	A coil of iron wire wound on a porcelain core in series with a lamp and battery is heated until the lamp goes out.
5D20.20	heated wire	Heat a coil of iron wire in series with a battery and a lamp.
5D20.21	flame	A coil of nickel wire connected to a battery and galvanometer is heated in a flame.
5D20.30	pos and neg resistance coefficients	Measure current and resistance at various voltages for a carbon and tungsten bulb.
5D20.30	carbon and tungsten lamps	Plot current vs. voltage for carbon and tungsten lamps.
5D20.31	resistance of light bulbs	The V/I curves for tungsten and carbon filament lamps are shown on a dual trace storage oscilloscope.
5D20.32	temperature of incandescent lamps	Two silicon solar cells with interference filters measure the light at different wavelengths for use in determining the temperature of the filament.
5D20.40	resistance thermometer	Attach No. 14 copper leads to a platinum coil and use with a Wheatstone bridge.
5D20.50	thermistors	Use a good kit of commercial thermistors and display the differential negative resistance of a fast thermistor on a transistor curve tracer.
5D20.50	thermistor	Show the resistance of a thermistor placed in an ice water bath.
5D20.60	conduction in glass at high temp	A simple version of glass conduction using binder clips and window glass.
5D20.60	conduction in glass at high temp	Heat a capillary tube in a Bunsen burner until it is hot enough to sustain a current that maintains a bright glow.
5D20.60	conduction in glass	Heat a glass tube with a flame until it is hot enough to sustain conduction. Vary the current by changing the ballast resistance.
5D20.61	negative temp coeff of resistance	A Nerst glower must be heated with a flame until the resistance is low enough to sustain electrical heating.

Conduction in Solution

PIRA #	Demonstration Name	Abstract
5D30.10	conductivity of solutions	Dip two metal electrodes in series with a light bulb in various solutions.
5D30.10	conduction thru electrolytes	Immerse two copper plates in series with a lamp in distilled water, add barium hydroxide, then sulfuric acid.
5D30.10	conduction thru electrolytes	Put two copper plates in series with a lamp in distilled water and salt or acid is added.
5D30.10	conductivity of solutions	Two electrodes in series with a 110 V lamp are dipped into distilled water, salt water, a sugar solution, a vinegar solution, and tap water.
5D30.13	salt water string
5D30.15	electrolytic conduction on chamios	Suspend a chamois between ringstands, show no conduction with a battery, resistor, meter. Soak in distilled water, repeat, then sprinkle on salt
5D30.20	speed of ions	Show KMnO4 migrating with current towards the positive electrode in KNO3.
5D30.20	migration of ions	Permanganate ions migrate in an electric field.
5D30.21	ionic speed	Dip two platinum electrodes into an ammoniated copper sulfate solution containing some phenophthalein.
5D30.22	ionic speed	Blue moves from the anode of in a potassium chloride gel when 120 volts is applied.
5D30.23	ionic speed	Measuring the speed of hydrogen and hydroxyl ions in a potassium chloride gel.
5D30.30	pickle glow

[:Demonstrations:Demonstrations]

[:Instructional:Home]

-  ⇤ ← Revision 1 as of 2010-12-10 21:40:09 → 
  Size: 188
  Editor: srnarf
  Comment:
+   ← Revision 2 as of 2011-06-21 19:18:57 → ⇥
  Size: 6999
  Editor: srnarf
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 2:
-Line 8:
+Line 7:
+= Resistance Characteristics =
||<:10%>'''PIRA #'''||<:>'''Demonstration Name'''||<:60%>'''Abstract'''||
||	5D10.10	||	resistor assortment	||		||
||	5D10.11	||	scaled up resistor box	||	Rebuild an old resistance box with larger numbers.	||
||	5D10.20	||	characteristic resistances	||	Connect one meter lengths of various wires in series and measure the voltage across each.	||
||	5D10.20	||	characteristic resistance	||	Measure voltages on a commercial board with seven one meter lengths of various wires is series so all carry the same current.	||
||	5D10.20	||	resistance wires	||	Place 6V across a set of wires of different lengths and/or diameters and measure the currents.	||
||	5D10.22	||	resistance characteristic of arc	||	Measure the current and potential across a small arc as the series resistance is varied.	||
||	5D10.40	||	resistance model	||	Balls are rolled down an incline with pegs.	||
||	5D10.40	||	model of resistance	||	A ball is rolled down a board with randomly spaced nails.	||
||	5D10.40	||	charge motion demonstrator	||	Small balls are rolled down a board with nails scattered in an almost random pattern. Diagram.	||
||	5D10.40	||	electron motion model	||	Ball bearings are simultaneously rolled down two ramps, one with pegs and one without.	||
||	5D10.50	||	current model with Wimshurst	||		||


= Resistivity and Temperature =
||<:10%>'''PIRA #'''||<:>'''Demonstration Name'''||<:60%>'''Abstract'''||
||	5D20.10	||	wire coil in liquid nitrogen	||	A lamp glows brighter when a series resistance coil is immersed in liquid nitrogen.	||
||	5D20.10	||	resistance at low temperature	||	A lamp glows brighter when a series resistance coil is immersed in liquid air.	||
||	5D20.10	||	cooled wire	||	A copper coil in series with a battery and lamp is immersed in liquid nitrogen.	||
||	5D20.11	||	resistance at low temperature	||	A "C" battery, 3 V flashlight bulb, and a copper wire coil make a hand held temp coefficient of resistivity apparatus.	||
||	5D20.12	||	audible temp-dependent resistance	||	The resistor plunged into liquid nitrogen is part of a voltage controlled oscillator that drives a speaker.	||
||	5D20.12	||	cooling	||	Current is increased in a long U of iron wire until it glows, then half is inserted into a beaker of water.	||
||	5D20.14	||	superconducting wire	||	Cool a coil of NbTi wire in a series circuit with a 12 volt car battery and lamp first in liquid nitrogen, then helium. The voltage across the coil is monitored and the lamp brightness is observed.	||
||	5D20.15	||	flame and liquid nitrogen	||	Resistance coils are heated and cooled with a test light bulb in series.	||
||	5D20.15	||	temperature dependence of resistance	||	Two sets of bulbs in series with coils, one put in liquid nitrogen and the other in a flame.	||
||	5D20.16	||	temperature coefficent of resistance	||	Two coils of different material but the same resistance are placed in a Wheatstone bridge and either is heated or cooled.	||
||	5D20.20	||	iron wire in flame	||	Heat a coil of iron wire in series with a battery and a lamp and the lamp will dim.	||
||	5D20.20	||	iron wire in a flame	||	A coil of forty turns of iron wire is heated in a flame while connected in series with a light bulb circuit.	||
||	5D20.20	||	putting the light out by heat	||	A coil of iron wire wound on a porcelain core in series with a lamp and battery is heated until the lamp goes out.	||
||	5D20.20	||	heated wire	||	Heat a coil of iron wire in series with a battery and a lamp.	||
||	5D20.21	||	flame	||	A coil of nickel wire connected to a battery and galvanometer is heated in a flame.	||
||	5D20.30	||	pos and neg resistance coefficients	||	Measure current and resistance at various voltages for a carbon and tungsten bulb.	||
||	5D20.30	||	carbon and tungsten lamps	||	Plot current vs. voltage for carbon and tungsten lamps.	||
||	5D20.31	||	resistance of light bulbs	||	The V/I curves for tungsten and carbon filament lamps are shown on a dual trace storage oscilloscope.	||
||	5D20.32	||	temperature of incandescent lamps	||	Two silicon solar cells with interference filters measure the light at different wavelengths for use in determining the temperature of the filament.	||
||	5D20.40	||	resistance thermometer	||	Attach No. 14 copper leads to a platinum coil and use with a Wheatstone bridge.	||
||	5D20.50	||	thermistors	||	Use a good kit of commercial thermistors and display the differential negative resistance of a fast thermistor on a transistor curve tracer.	||
||	5D20.50	||	thermistor	||	Show the resistance of a thermistor placed in an ice water bath.	||
||	5D20.60	||	conduction in glass at high temp	||	A simple version of glass conduction using binder clips and window glass.	||
||	5D20.60	||	conduction in glass at high temp	||	Heat a capillary tube in a Bunsen burner until it is hot enough to sustain a current that maintains a bright glow.	||
||	5D20.60	||	conduction in glass	||	Heat a glass tube with a flame until it is hot enough to sustain conduction. Vary the current by changing the ballast resistance.	||
||	5D20.61	||	negative temp coeff of resistance	||	A Nerst glower must be heated with a flame until the resistance is low enough to sustain electrical heating.	||


= Conduction in Solution =
||<:10%>'''PIRA #'''||<:>'''Demonstration Name'''||<:60%>'''Abstract'''||
||	5D30.10	||	conductivity of solutions	||	Dip two metal electrodes in series with a light bulb in various solutions.	||
||	5D30.10	||	conduction thru electrolytes	||	Immerse two copper plates in series with a lamp in distilled water, add barium hydroxide, then sulfuric acid.	||
||	5D30.10	||	conduction thru electrolytes	||	Put two copper plates in series with a lamp in distilled water and salt or acid is added.	||
||	5D30.10	||	conductivity of solutions	||	Two electrodes in series with a 110 V lamp are dipped into distilled water, salt water, a sugar solution, a vinegar solution, and tap water.	||
||	5D30.13	||	salt water string	||		||
||	5D30.15	||	electrolytic conduction on chamios	||	Suspend a chamois between ringstands, show no conduction with a battery, resistor, meter. Soak in distilled water, repeat, then sprinkle on salt	||
||	5D30.20	||	speed of ions	||	Show KMnO4 migrating with current towards the positive electrode in KNO3.	||
||	5D30.20	||	migration of ions	||	Permanganate ions migrate in an electric field.	||
||	5D30.21	||	ionic speed	||	Dip two platinum electrodes into an ammoniated copper sulfate solution containing some phenophthalein.	||
||	5D30.22	||	ionic speed	||	Blue moves from the anode of in a potassium chloride gel when 120 volts is applied.	||
||	5D30.23	||	ionic speed	||	Measuring the speed of hydrogen and hydroxyl ions in a potassium chloride gel.	||
||	5D30.30	||	pickle glow	||		||

fw: Diff for "Resistance"

Resistance

Resistance Characteristics

Resistivity and Temperature

Conduction in Solution